HTC Inspire 4G A9192 (HTC Stallion) Unbrick, Boot, IMEI, CID, ModelID, Unlock supported

alamgarh · 02-02-2012, 09:38 AM

Resurrecting HTC Inspire is easy. Phone is auto powered on with USB Data Cable connected to the PC while battery is connected.
Some (or all) revisions of HTC Inspire boards have JTAG interface disabled (that is enable MARM JTAG Fuse is ****n in the MSM chip). In this case the JTAG may be enabled only by firmware itself. This is done by the FSBL loader, so writing to FSBL area is artificially disabled in the DCC Loader code. DCC Loader will discard all flashing attempts into FSBL zone and will respond with success code as if flashing succeeded. In this way FSBL zone is protected while user still can flash full image files seamlessly.
Resurrector will reflash radio’s boot zone (except FSBL area) and will re-write PDA’s SPL version 0.85.0024. Additionally to SPL and Radio zones, the zone which contains Model ID is re-flashed too. Thus after resurrection phone will have Model ID = ‘PD9812000’.
There is option to reflash BOOT and RECOVERY zones.
Please note, if your phone has the FSBL loader damaged and MCU has JTAG FUSE ****n then there is no way to resurrect your phone via JTAG interface.
To resurrect HTC Inspire:

Solder JTAG cable to HTC Inspire JTAG pads;
Insert batter and connect USB Data cable;
Make sure HTC Inspire is selected in the list of models;
If you use only battery, press Power On key;
Click Resurrect button;
Wait till software signals a successful operation completion;
Disconnect power supply, de-solder JTAG wires;

Now phone is in bootable condition, that is, even if it does not start up normally you can flash it using known flashing methods.
To enter download mode:

Disconnect PC cable;
Insert battery;
Hold ‘Volume Down’ key and press ‘Power ON’ button.

_

02-02-2012, 09:38 AM	#1 (permalink)
alamgarh Super Moderator Join Date: Jun 2008 Posts: 2,619 Thanks: 21 Thanked 636 Times in 270 Posts Rep Power: 14	HTC Inspire 4G A9192 (HTC Stallion) Unbrick, Boot, IMEI, CID, ModelID, Unlock supported Resurrecting HTC Inspire is easy. Phone is auto powered on with USB Data Cable connected to the PC while battery is connected. Some (or all) revisions of HTC Inspire boards have JTAG interface disabled (that is enable MARM JTAG Fuse is **n in the MSM chip). In this case the JTAG may be enabled only by firmware itself. This is done by the FSBL loader, so writing to FSBL area is artificially disabled in the DCC Loader code. DCC Loader will discard all flashing attempts into FSBL zone and will respond with success code as if flashing succeeded. In this way FSBL zone is protected while user still can flash full image files seamlessly. Resurrector will reflash radio’s boot zone (except FSBL area) and will re-write PDA’s SPL version 0.85.0024. Additionally to SPL and Radio zones, the zone which contains Model ID is re-flashed too. Thus after resurrection phone will have Model ID = ‘PD9812000’. There is option to reflash BOOT and RECOVERY zones. Please note, if your phone has the FSBL loader damaged and MCU has JTAG FUSE n then there is no way to resurrect your phone via JTAG interface. To resurrect HTC Inspire: Solder JTAG cable to HTC Inspire JTAG pads; Insert batter and connect USB Data cable; Make sure HTC Inspire is selected in the list of models; If you use only battery, press Power On key; Click Resurrect button; Wait till software signals a successful operation completion; Disconnect power supply, de-solder JTAG wires; Now phone is in bootable condition, that is, even if it does not start up normally you can flash it using known flashing methods. To enter download mode:** Disconnect PC cable; Insert battery; Hold ‘Volume Down’ key and press ‘Power ON’ button. _

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RIFF JTAG - SonyEricsson Unlock/IMEI/TA Repair supported	alamgarh	Rocker Dongle (By Legija)	0	11-12-2011 04:47 AM
RIFF JTAG - SonyEricsson Unlock/IMEI/TA Repair supported	alamgarh	*GSM News & updates*	0	11-12-2011 04:43 AM
RIFF JTAG - Samsung T749, Samsung E189 Unbrick - Boot repair supported	alamgarh	*GSM News & updates*	0	07-12-2011 01:29 PM
RIFF JTAG - Huawei E153U Broadband modem unbrick – dead boot repair supported	alamgarh	*GSM News & updates*	0	03-17-2011 01:14 PM
RIFF JTAG - Toshiba Portege G900 Unbrick, Dead Boot repair supported	alamgarh	*GSM News & updates*	0	03-15-2011 02:25 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)